First simulation by Jozsef Nagy
Revision as of 11:50, 23 October 2017 by Jozsef Nagy (talk | contribs)
- contributor: Jozsef Nagy
- affiliation: Institute of Polymer Injection Molding and Process Automation, Johannes Kepler University Linz, Austria
- contact: click here for email address
- OpenFOAM versions: 4.x, v1706
- published under: CC BY-NC-SA license (creative commons licenses)
Go back to Day 1.
Go back to "first glimpse" series
First simulation in OpenFOAM
In these videos
you will learn about
- the basic case setup of OpenFOAM
- the initial values of your simulation
- the mesh (e.g. the boundaries)
- running the simulation of the flow in a 2D elbow case with three different meshes
- post processing
You will familiarize yourself with the terminal in Linux, where you will run all your simulations in OpenFOAM. You will also get a first idea on the work flow that you have to follow in order to run a successful simulation.
You can download the .msh file here:
(left click on it, then right click on Raw, then save as)