BlockMesh by Jozsef Nagy
Revision as of 10:58, 28 September 2016 by Jozsef Nagy (talk | contribs)
- contributor: Jozsef Nagy
- affiliation: Institute of Polymer Injection Molding and Process Automation, Johannes Kepler University Linz, Austria
- contact: click here for email address
- OpenFOAM version: 2.3.0
- Published under: CC BY-NC-SA license (creative commons licenses)
Go back to Day 1.
blockMesh with a more complicated case
In this video you will get a detailed introduction into the dictionary describing the input of blockMesh. This time we will use a more detailed geometry of the forwardStep. You will learn about
- scaling the mesh
- setting the vertices
- setting volumes (blocks)
- setting edges
- boundaries
- grading
We will also run and post process the case, however the focus is on the meshing part of a CFD project.
- contributor: Bahram Haddadi, Jozsef Nagy and Christian Jordan
- affiliation: Forschungsgruppe Thermische Verfahrenstechnik & Fluiddynamische Simulation am Institut für Verfahrenstechnik der Technischen Universität Wien, Austria
- contact: bahram.haddadi.sisakht@tuwien.ac.at
- OpenFOAM version: 2.3.0
- Published under: CC BY-NC-SA license ([https:// creativecommons.org/licenses creative commons licenses])
- additional acknowledgements: Clemens Gößnitzer, Vikram Natarajan, Sylvia Zibuschka, Michael Harasek
[http:// www.cfd.at/downloads/2014_OFoam_Tut_Example%20Two.pdf blockMesh with a more complicated case]
In this [http:// www.cfd.at/downloads/2014_OFoam_Tut_Example%20Two.pdf pdf] you will find a written step-by-step walkthrough of the tutorial above.