Difference between revisions of "BlockMesh by Jozsef Nagy"

From OpenFOAM Wiki
Jump to navigation Jump to search
(7 intermediate revisions by the same user not shown)
Line 1: Line 1:
 +
[[category:meshing]]
 
* '''contributor''': Jozsef Nagy
 
* '''contributor''': Jozsef Nagy
* '''affiliation''': Institute of Polymer Injection Molding and Process Automation, Johannes Kepler University Linz, Austria
+
* '''affiliation''': eulerian-solutions e.U., Linz, Austria
* '''contact''': <mail address='jozsef.nagy@jku.at' description='author'>click here for email address</mail>
+
* '''contact''': <mail address='jnmlujnmlu@gmail.com' description='author'>click here for email address</mail>
* '''OpenFOAM versions''': 2.3.0, 2.3.1, 2.4.0, 3.0.0, 3.0.1, 4.0, 4.1, 1606+, 1612+
+
* '''OpenFOAM versions''': v2006
 
* '''Published under''': CC BY-NC-SA license ([https://creativecommons.org/licenses creative commons licenses])
 
* '''Published under''': CC BY-NC-SA license ([https://creativecommons.org/licenses creative commons licenses])
  

Revision as of 04:55, 28 July 2020

Go back to Day 1.

blockMesh with a more complicated case

pressure distribution

In this video you will get a detailed introduction into the dictionary describing the input of blockMesh. This time we will use a more detailed geometry of the forwardStep. You will learn about

  • scaling the mesh
  • setting the vertices
  • setting volumes (blocks)
  • setting edges
  • boundaries
  • grading

We will also run and post process the case, however the focus is on the meshing part of a CFD project.

For older versions of OpenFOAM the blockMeshDict file is located in constant/polyMesh, for newer versions the file is located in system.