Difference between revisions of "BlockMesh by Jozsef Nagy"

From OpenFOAM Wiki
Jump to navigation Jump to search
(Created page with "* '''author''': Jozsef Nagy * '''affiliation''': Universita degli Studi di Genova, Wolf Dynamics * '''contact''': joel.guerrero@unige.it * '''OpenFOAM version''': 3.0 * '''Pub...")
 
(26 intermediate revisions by 2 users not shown)
Line 1: Line 1:
* '''author''': Jozsef Nagy
+
[[category:meshing]]
* '''affiliation''': Universita degli Studi di Genova, Wolf Dynamics
+
* '''contributor''': Jozsef Nagy
* '''contact''': joel.guerrero@unige.it
+
* '''affiliation''': eulerian-solutions e.U., Linz, Austria
* '''OpenFOAM version''': 3.0
+
* '''contact''': <mail address='jnmlujnmlu@gmail.com' description='author'>click here for email address</mail>
* '''Published under''': CC ??? license
+
* '''OpenFOAM versions''': v2006
 +
* '''Published under''': CC BY-NC-SA license ([https://creativecommons.org/licenses creative commons licenses])
  
=How to install OpenFOAM=
+
Go back to [https://wiki.openfoam.com/index.php?title=Day_1 Day 1].
  
This pdf describes how to install OpenFOAM.
+
=[https://www.youtube.com/watch?v=Ds0eK1wXMks blockMesh with a more complicated case]=
 +
 
 +
[[File:Pressure_jnagy.png|450px|right|pressure distribution]]
 +
 
 +
In this [https://www.youtube.com/watch?v=Ds0eK1wXMks video] you will get a detailed introduction into the dictionary describing the input of blockMesh. This time we will use a more detailed geometry of the forwardStep. You will learn about
 +
 
 +
* scaling the mesh
 +
* setting the vertices
 +
* setting volumes (blocks)
 +
* setting edges
 +
* boundaries
 +
* grading
 +
 
 +
We will also run and post process the case, however the focus is on the meshing part of a CFD project.
 +
 
 +
For older versions of OpenFOAM the blockMeshDict file is located in constant/polyMesh, for newer versions the file is located in system.

Revision as of 04:55, 28 July 2020

Go back to Day 1.

blockMesh with a more complicated case

pressure distribution

In this video you will get a detailed introduction into the dictionary describing the input of blockMesh. This time we will use a more detailed geometry of the forwardStep. You will learn about

  • scaling the mesh
  • setting the vertices
  • setting volumes (blocks)
  • setting edges
  • boundaries
  • grading

We will also run and post process the case, however the focus is on the meshing part of a CFD project.

For older versions of OpenFOAM the blockMeshDict file is located in constant/polyMesh, for newer versions the file is located in system.