BlockMesh by Jozsef Nagy
Revision as of 14:15, 19 January 2017 by Jozsef Nagy (talk | contribs)
- contributor: Jozsef Nagy
- affiliation: Institute of Polymer Injection Molding and Process Automation, Johannes Kepler University Linz, Austria
- contact: click here for email address
- OpenFOAM version: 2.3.0, 2.3.1, 2.4.0, 3.0.0, 3.0.1, 4.0, 4.1, 1606+, 1612+
- Published under: CC BY-NC-SA license (creative commons licenses)
Go back to Day 1.
blockMesh with a more complicated case
In this video you will get a detailed introduction into the dictionary describing the input of blockMesh. This time we will use a more detailed geometry of the forwardStep. You will learn about
- scaling the mesh
- setting the vertices
- setting volumes (blocks)
- setting edges
- boundaries
- grading
We will also run and post process the case, however the focus is on the meshing part of a CFD project.
For older versions of OpenFOAM the blockMeshDict file is located in constant/polyMesh, for newer versions the file is located in system