BlockMesh by Jozsef Nagy

From OpenFOAM Wiki
Revision as of 11:55, 13 December 2016 by Jozsef Nagy (talk | contribs)
Jump to navigation Jump to search
  • contributor: Jozsef Nagy
  • affiliation: Institute of Polymer Injection Molding and Process Automation, Johannes Kepler University Linz, Austria
  • contact: click here for email address
  • OpenFOAM version: 2.3.0
  • Published under: CC BY-NC-SA license (creative commons licenses)

Go back to Day 1.

blockMesh with a more complicated case

pressure distribution

In this video you will get a detailed introduction into the dictionary describing the input of blockMesh. This time we will use a more detailed geometry of the forwardStep. You will learn about

  • scaling the mesh
  • setting the vertices
  • setting volumes (blocks)
  • setting edges
  • boundaries
  • grading

We will also run and post process the case, however the focus is on the meshing part of a CFD project.