First simulation by Jozsef Nagy
Revision as of 04:51, 15 September 2016 by Jozsef Nagy (talk | contribs)
- author: Jozsef Nagy
- affiliation: Institute of Polymer Injection Molding and Process Automation, Johannes Kepler University Linz, Austria
- contact: jozsef.nagy@jku.at
- OpenFOAM version: 2.3.0
- published under: CC BY-NC-SA license ([https:// creativecommons.org/licenses creative commons licenses])
Go back to Day 1.
[https:// www.youtube.com/watch?v=KznljrgWSvo First simulation in OpenFOAM]
In these videos
- [https:// www.youtube.com/watch?v=KznljrgWSvo part 1]
- [https:// www.youtube.com/watch?v=bJTSKaxG58Y part 2]
you will learn about
- the basic case setup of OpenFOAM
- the initial values of your simulation
- the mesh (e.g. the boundaries)
- running the simulation of the flow in a 2D elbow case with three different meshes
- postprocessing
You will familiarize yourself with the terminal in Linux, where you will run all your simulations in OpenFOAM. You will also get a first idea on the work flow, that you have to follow in order to run a successful simulation.