Difference between revisions of "OneraM6 by Michael Alletto"
Line 18: | Line 18: | ||
The scope of this tutorials is to test the capability of the solver rhoSimpleFoam in combination with the OpenFOAM native mesher snappyHexMesh to simulate 3D transonic flows over wings. For this purpose we take as test case the Onera M6 wing listed in the NASA turbulence model resource home page https://turbmodels.larc.nasa.gov/index.html. The home page provides a list of test cases to validate turbulence models for compressible and incompressible flows. The flow around the Onera M6 wing is taken as one of the standard test cases to validate compressible flow solvers (see, e.g. [1],[2],[4]). | The scope of this tutorials is to test the capability of the solver rhoSimpleFoam in combination with the OpenFOAM native mesher snappyHexMesh to simulate 3D transonic flows over wings. For this purpose we take as test case the Onera M6 wing listed in the NASA turbulence model resource home page https://turbmodels.larc.nasa.gov/index.html. The home page provides a list of test cases to validate turbulence models for compressible and incompressible flows. The flow around the Onera M6 wing is taken as one of the standard test cases to validate compressible flow solvers (see, e.g. [1],[2],[4]). | ||
+ | |||
+ | ==Set up== | ||
+ | |||
+ | ===Mesh generation=== | ||
+ | |||
+ | ===Simulation setup=== | ||
+ | |||
+ | ==Results== | ||
Revision as of 13:13, 27 October 2020
- contributor: Michael Alletto
- affiliation: WRD MS
- contact: click here for email address
- OpenFOAM versions: v2006
- Published under: CC BY-NC-ND license (creative commons licenses)
Go back to Collection by authors.
Contents
Transonic flow around the 3D Onera M6 wing at an angle of attack of 3.06°
You can download the case file [1] here.
Introduction
The scope of this tutorials is to test the capability of the solver rhoSimpleFoam in combination with the OpenFOAM native mesher snappyHexMesh to simulate 3D transonic flows over wings. For this purpose we take as test case the Onera M6 wing listed in the NASA turbulence model resource home page https://turbmodels.larc.nasa.gov/index.html. The home page provides a list of test cases to validate turbulence models for compressible and incompressible flows. The flow around the Onera M6 wing is taken as one of the standard test cases to validate compressible flow solvers (see, e.g. [1],[2],[4]).
Set up
Mesh generation
Simulation setup
Results
References
[1] J Mayeur, A Dumont, D Destarac, and V Gleize. Reynolds-averaged navier–stokes simulations on naca0012 and onera-m6 wing with the onera elsa solver. AIAA Journal, 54(9):2671–2687, 2016.
[2] Davide Modesti and Sergio Pirozzoli. A low-dissipative solver for turbu- lent compressible flows on unstructured meshes, with openfoam imple- mentation. Computers & Fluids, 152:14–23, 2017.
[3] Fadl Moukalled, L Mangani, Marwan Darwish, et al. The finite volume method in computational fluid dynamics, volume 113. Springer, 2016.
[4] L Remaki, O Hassan, and K Morgan. Aerodynamic computations using a finite volume method with an hllc numerical flux function. Mathematical Modelling of Natural Phenomena, 6(3):189–212, 2011.