Difference between revisions of "Suzanne by Tobias Holzmann"
Jump to navigation
Jump to search
Jozsef Nagy (talk | contribs) (Created page with "category:basic tutorial category:laminar * '''contributor''': Tobias Holzmann * '''affiliation''': Holzmann CFD * '''contact''': <mail address='Tobias.Holzmann@Holzman...") |
Jozsef Nagy (talk | contribs) |
||
| Line 9: | Line 9: | ||
Go back to [https://wiki.openfoam.com/Collection_of_the_basics Basics]. | Go back to [https://wiki.openfoam.com/Collection_of_the_basics Basics]. | ||
| − | = | + | =Drag coefficient of a monkey head - Suzanne= |
In this tutorial you will learn, how to set up a basic case for the calculation of the drag coefficient of a monkey head. | In this tutorial you will learn, how to set up a basic case for the calculation of the drag coefficient of a monkey head. | ||
Revision as of 07:30, 24 November 2017
- contributor: Tobias Holzmann
- affiliation: Holzmann CFD
- contact: click here for email address
- OpenFOAM version: 5.x
- published under: GPL v3 license
Go back to Basics.
Contents
Drag coefficient of a monkey head - Suzanne
In this tutorial you will learn, how to set up a basic case for the calculation of the drag coefficient of a monkey head.
7.1 Introduction to the Suzanne Training Session
- Brief introduction about the challenge
- Further information based on the screencast of Joszef Nagy
7.2 Generate, Smooth and Close the Monkey Head
- How to generate the monkey head in Blender
- Demonstrating three different ways of surface smoothing
- Closing the eyes using some nice Blenderfunctions
7.3 Calculate the Projected Area of the Monkey Head
- A nice technique to calculate the projected area of Suzannes complex head
7.4 Create the OpenFOAMcase
- Building the mesh
- Set-up the case with special focus on the drag coefficient calculation
- Run the simulation
