Difference between revisions of "Multiphase (VOF) Simulation Project by Jozsef Nagy"
Jozsef Nagy (talk | contribs) (Created page with "* '''contributor''': Jozsef Nagy * '''affiliation''': Institute of Polymer Injection Molding and Process Automation, Johannes Kepler University Linz, Austria * '''contact''':...") |
Jozsef Nagy (talk | contribs) |
||
| Line 11: | Line 11: | ||
[[File:Pressure_jnagy.png|450px|right|pressure distribution]] | [[File:Pressure_jnagy.png|450px|right|pressure distribution]] | ||
| − | In this [ | + | In this [https://github.com/jnmlujnmlu/OpenFOAMTeaching/tree/master/JozsefNagy/WorkshopExeter teaching session] a simulation project is presented with a special focus on multiphase modeling (Volume-of-Fluid). The basic idea is to show how to conduct a simulation project from a predefined geometry until post-processing. After a small introduction to the physics involved in this tutorial as well as the implementation in OpenFOAM, a live step-by-step presentation of the mesh creation, the case setup, the simulation itself as well as the post-processing of the simulation results will be given (see figure below). A special focus is on the understanding of the needed steps in a typical workflow in OpenFOAM. For this reason dictionaries are fully commented. This way users can later come back and quickly and easily refresh the information gathered during the teaching session. |
* [https://github.com/jnmlujnmlu/OpenFOAMTeaching/blob/master/JozsefNagy/WorkshopExeter/fillingOfTank.pdf pdf] | * [https://github.com/jnmlujnmlu/OpenFOAMTeaching/blob/master/JozsefNagy/WorkshopExeter/fillingOfTank.pdf pdf] | ||
* [https://github.com/jnmlujnmlu/OpenFOAMTeaching/blob/master/JozsefNagy/WorkshopExeter/fillingOfTank.zip case] | * [https://github.com/jnmlujnmlu/OpenFOAMTeaching/blob/master/JozsefNagy/WorkshopExeter/fillingOfTank.zip case] | ||
Revision as of 05:10, 1 June 2017
- contributor: Jozsef Nagy
- affiliation: Institute of Polymer Injection Molding and Process Automation, Johannes Kepler University Linz, Austria
- contact: click here for email address
- OpenFOAM versions: 4.1, 1606+, 1612+
- Published under: CC BY-NC-SA license (creative commons licenses)
Go back to the collection of training material.
Multiphase (VOF) Simulation Project
In this teaching session a simulation project is presented with a special focus on multiphase modeling (Volume-of-Fluid). The basic idea is to show how to conduct a simulation project from a predefined geometry until post-processing. After a small introduction to the physics involved in this tutorial as well as the implementation in OpenFOAM, a live step-by-step presentation of the mesh creation, the case setup, the simulation itself as well as the post-processing of the simulation results will be given (see figure below). A special focus is on the understanding of the needed steps in a typical workflow in OpenFOAM. For this reason dictionaries are fully commented. This way users can later come back and quickly and easily refresh the information gathered during the teaching session.
